Huawei Quidway S8500 Series User Manual

Command Manual – Network Protocol
Quidway S8500 Series Routing Switches Chapter 3 ARP Table Size Configuration Commands
Huawei Technologies Proprietary
3-3
View
System view
Parameter
4: Configures the maximum number of ARP entries of the whole switch to 4K (1K =
1024).
64: Configure the maximum number of ARP entries of the whole switch to 64K.
Description
Use the arp enable size command to configure the maximum number of ARP entries
that can be supported by the whole switch.
Use the undo arp enable size command to restore the default maximum number of
ARP entries supported by the whole switch.
By default, the whole switch supports up to 4K ARP entries, each card supports up to
4K ARP entries, and each card supports up to 1K aggregation ARP entries.
Example
# Configure the maximum number of ARP entries of the whole switch to 64K.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] arp enable size 64
The configuration won't be enabled until the system is rebooted.
Caution:
z You must restart the system for each of the three configurations to take effect.
z Do not remove a card or change the place of a card from one slot to another before
restarting the system. Otherwise, the configuration may fail to take effect.
z After the configurations, do not perform active/standby switchover before restarting
the system. Otherwise, the configurations will not take effect even if you restart the
system.
3.1.4 display arp max-entry
Syntax
display arp max-entry

Huawei Quidway S8500 Series Specifications

General

Brand	Huawei
Model	Quidway S8500 Series
Category	Switch
Language	English