Command Manual – Multicast Protocol
Quidway S8500 Series Routing Switches Chapter 1 IGMP Snooping Configuration Commands
Huawei Technologies Proprietary
1-3
Parameter
vlan vlan-id: Specifies the VLAN where the multicast group to be viewed is located.
When the parameter is omitted, the command will display the information about all the
multicast groups on the VLAN.
Description
Use the display igmp-snooping group command to view the IP multicast group and
MAC multicast group information of a VLAN or all the VLAN where the Ethernet switch
is located. It displays the information such as VLAN ID, router port, IP multicast group
address, member ports in the IP multicast group, MAC multicast group, MAC multicast
group address, and the member ports in the MAC multicast group.
Example
# Display the multicast group information about VLAN2.
<Quidway> display igmp-snooping group vlan 2
***************Multicast group table***************
Vlan(id):2.
Router port(s):Ethernet3/1/1
IP group(s):the following ip group(s) match to one mac group.
IP group address:230.45.45.1
Member port(s):Ethernet3/1/12
MAC group(s):
MAC group address:01-00-5e-2d-2d-01
Member port(s):Ethernet3/1/12
We can know from the information listed above that:
z There is a multicast group in VLAN 2;
z The router port is Ethernet 2/1/1;
z The IP multicast group address is 230.45.45.1;
z The member of the IP multicast group is Ethernet 2/1/2;
z MAC multicast group is 0100-5e2d-2d01;
z The member of the MAC multicast group is Ethernet 2/1/2.
1.1.4 display igmp-snooping statistics
Syntax
display igmp-snooping statistics
View
Any view
To Next Page
Loading...
Need help?
General