Command Manual – System Management
Quidway S8500 Series Routing Switches Chapter 4 System Maintenance Commands
Huawei Technologies Proprietary
4-22
module-name: Module name.
Description
Use the display debugging command to display debugging switches that have been
turned on.
You can execute the display debugging to view which debugging switches have been
turned on. If the command is executed without any parameter, the system will display
all debugging switches that have been turned on.
Related command: debugging.
Example:
# Display all debugging switches that have been turned on.
<Quidway> display debugging
Multicast packet forwarding debugging switch is on
4.3.3 display fiber-module
Syntax
display fiber-module [ interface-type interface-number ]
View
Any view
Parameter
interface-type: The interface type supported by switch. the value can be Ethernet,
GigabitEthernet and so on.
interface-number: Interface number.
Description
Use the display fiber-module command to display the information of the optical
modules connected with all the optical interfaces in position on the current shelf,
including module information, optical module type, connector type, vendor name,
manufacturer part number, single mode or multi-mode, wave length, transmission
distance and so on.
Use the display fiber-module [ interface-type interface-number | interface-name ]
command to display optical module information of the specified port.
Example
# Display the optical module information of all optical interfaces in position on the
current shelf.
<Quidway> display fiber-module
To Next Page
Loading...
Need help?
General