Command Manual – Port
Quidway S8500 Series Routing Switches Chapter 3 POS Port Configuration Commands
Huawei Technologies Proprietary
3-3
[Quidway] interface pos2/1/1
[Quidway-Pos2/1/1] description pos-interface
3.1.4 display interface pos
Syntax
display interface pos [ interface-number ]
View
Any view
Parameter
interface-number: POS port number, in the format of board slot ID/daughter card slot
ID/ port ID, where board slot ID refers to the ID of the slot for LPU, in the range of 2 to 6
(for S8505), or 0 to 3 and 6 to 9 (for S8508), or 0 to 5 and 8 to 13 (for S8512); daughter
card slot ID refers to the ID of the slot for daughter, with the value of 1; port ID refers to
the sequence number on the LPU for the port, in the range of 1 to 4.
Description
Use the display interface pos command to view the configuration and status
information of a designated POS port. If no interface number is specified, the command
displays the configuration and status information of all POS ports.
Example
# Display the configuration and status information of POS2/1/1.
<Quidway> display interface pos2/1/1
Pos2/1/1 current state : UP
Link layer protocol current state : UP
Physical layer is Packet over SDH,loopback not set
Ip address of POS Access VLAN's interface is: 200.4.0.2
Ip Mask of POS Access VLAN's interface is: 255.255.255.0
Description: No description!
The Maximum Transmit Unit is 1500
Port hardware type is POS OC48/STM-16-SR-SM
Access VLAN of POS port is 2004
Link layer protocol is PPP
LCP opened, IPCP opened, OSICP opened, MPLSCP opened
Hold timer is: 10 sec
FCS: 16-bit CRC
Clock Source: Master
SPE Scrambling: Disable
SDH alarm:
To Next Page
Loading...
Need help?
General