Huawei Quidway S8500 Series - Page 97

Command Manual – Port
Quidway S8500 Series Routing Switches Chapter 3 POS Port Configuration Commands
Huawei Technologies Proprietary
3-4
section layer:
line layer:
path layer:
C2(Rx) :0xcf C2(Tx): 0x16
J0(Rx): "quidway "
71 75 69 64 77 61 79 00 00 00 00 00 00 00 00 00 *quidway.........*
J0(Tx): "quidway"
71 75 69 64 77 61 79 00 00 00 00 00 00 00 00 00 *quidway.........*
J1(Rx): "quidway "
71 75 69 64 77 61 79 00 00 00 00 00 00 00 00 00 *quidway.........
J1(Tx): "quidway"
71 75 69 64 77 61 79 00 00 00 00 00 00 00 00 00 *quidway.........*
BER thresholds: SD = 10e-6 SF = 10e-3
SDH error:
section layer: B1 0
line layer: B2 0 M1 0
path layer: B3 0 G1 0
Last 5 minutes output: 0 packets/sec 1664 bits/sec 0%
Last 5 minutes input: 0 packets/sec 1584 bits/sec 0%
input: 1731 packets, 16913416468 bytes
0 errors, 0 CRC, 0 giants
0 pads, 0 aborts, 0 overflows
Output: 3953 packets, 1314756 bytes
0 errors, 0 underflows
Table 3-1 Description on the fields of the display interface pos command
Field Description
Pos2/1/1 current state Current state of the POS port
Link layer protocol current state Current state of the link layer protocol
Physical layer is Packet over SDH,
loopback not set
The physical layer uses SDH frame
mode, and loopback is not set on the
port.
Description Port description
The Maximum Transmit Unit MTU
Port hardware type Port hardware type
Link layer protocol Link layer protocol
LCP opened, IPCP opened, OSICP
opened, MPLSCP opened
Enabled protocols
Hold timer Interval time of the hold timer
FCS Check mode