Command Manual – Port
Quidway S8500 Series Routing Switches Chapter 3 POS Port Configuration Commands
Huawei Technologies Proprietary
3-10
Syntax
mtu mtu-value
View
POS port view
Parameter
mtu: MTU on the POS port.
mtu-value: MTU value, in the range of 64 to 9,192 (in bytes). By default, it is 1,500
bytes.
Note that the MTU range of 155M POS port and 10G POS port is different. The MTU of
155M POS port ranges from 64 to 1,995 bytes.
Description
Use the mtu command to define the MTU on the POS port.
Note that you must disable port by using the shutdown command first and then use the
undo shutdown command to enable it again if the MTU values are different between
both ends. In this case, as the result of negotiation between both ports, the smaller
value will be used as the MTU.
Example
# Set the MTU on the POS port to 5000 bytes.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] interface pos2/1/1
[Quidway-Pos2/1/1] mtu 5000
3.1.11 pos access vlan
Syntax
pos access vlan vlan-id
undo pos access vlan
View
POS port view
Parameter
vlan-id: VLAN ID defined in IEEE802.1Q, in the range of 2 to 4,094.
Description
To Next Page
Loading...
