Huawei Quidway S8500 Series - Garp Timer Leaveall; Reset Garp Statistics

Command Manual – VLAN&QinQ
Quidway S8500 Series Routing Switches Chapter 2
GARP/GVRP Configuration Commands
Huawei Technologies Proprietary
2-4
2.1.4 garp timer leaveall
Syntax
garp timer leaveall timer-value
undo garp timer leaveall
View
System view
Parameter
timer-value: Value of GARP LeaveAll timer in centiseconds, ranging from 65 to 32765.
The step is five centiseconds. The value of LeaveAll timer should be greater than the
value of Leave timer.
By default, the value of LeaveAll timer is 1000 centiseconds, i.e., 10s.
Description
Use the garp timer leaveall command to configure GARP LeaveAll timer.
Use the undo garp timer leaveall command to restore the default value.
After every GARP application entity is started, the LeaveAll timer will be started
simultaneously. The GARP application entity will send LeaveAll message after the
timer times out to make other application entities re-register all attribute information on
the entities themselves. Then, the LeaveAll timer is started and the new cycle begins.
Related command: display garp timer.
Example
# Set GARP LeaveAll timer to 1s.
[Quidway] garp timer leaveall 100
2.1.5 reset garp statistics
Syntax
reset garp statistics [ interface interface-list ]
View
User view
Parameter
interface-list: Specifies a list of Ethernet ports on which the GARP statistics information
will be cleared, expressed as interface-list = { interface-type interface-number [ to
interface-type interface-num] }&<1-10>. interface-type is interface type, and