Command Manual – Routing Protocol
Quidway S8500 Series Routing Switches Chapter 5 BGP Configuration Commands
Huawei Technologies Proprietary
5-2
Description
Use the aggregate command to establish an aggregated record in the BGP routing
table.
Use the undo aggregate command to disable the function.
By default, there is no route aggregation.
The keywords are explained as follows:
Table 5-1 The use of the keywords
Keyword Use
as-set
Used to produce an aggregated route, whose AS path
information includes detailed routes. Use this keyword
carefully when many AS paths need to be aggregated, for the
frequent change of routes may lead to route vibration.
detail-suppressed
This keyword does not suppress any aggregated route, but it
restrains the advertisement of all the specific routes. If only
some specific routes are to be restrained, use the peer
filter-policy command carefully.
suppress-policy
Create an aggregated route with this keyword. At the same
time, the advertisement of the specified route is restrained. If
you want to restrain some specific routes selectively and
leaves other routes still being advertised, use the if-match
sub-statement of the route-policy command.
origin-policy
Selects only the specific routes that are in accordance with
route-policy to create an aggregated route.
attribute-policy
Sets aggregated route attributes. The same work can be
done by using the peer route-policy command, etc.
Example
# Create an aggregated record in BGP routing table.
[Quidway-bgp] aggregate 168.328.0.0 255.255.0.0
5.1.2 Balance
Syntax
balance balance-number
undo balance
View
BGP view
To Next Page
Loading...
Need help?
General