Command Manual – Routing Protocol
Quidway S8500 Series Routing Switches Chapter 4 Integrated IS-IS Configuration Commands
Huawei Technologies Proprietary
4-33
Description
Use the set-overload command to set overload flag for the current router.
Use the undo set-overload command to cancel the overload flag.
By default, no overload flag is set.
If a router is configured with the overload flag, the routes it calculates will be ignored by
other routers in SPF calculation. (However the directly connected routes will not be
ignored.) And other routers should not send this router the packets which should be
forwarded by it.
Example
# Set overload flag on the current router.
[Quidway-isis] set-overload
4.1.39 silent-interface
Syntax
silent-interface silent-interface-type silent-interface-number
undo silent-interface silent-interface-type silent-interface-number
View
IS-IS view
Parameter
silent-interface-type: Specifies the interface type.
silent-interface-number: Specifies the interface number.
Description
Use the silent-interface command to disable a specified interface to transmit IS-IS
packet.
Use the undo silent-interface command to enable the interface to transmit IS-IS
packet.
By default, all the interface are allowed to transmit/receive IS-IS packets.
The silent-interface command is only used to suppress the packets to be transmitted
on the interface, but the routes of this interface will still be transmitted from other
interfaces.
Example
# Prohibit the IS-IS packets to be transmitted via Interface Vlan-interface 3.
[Quidway-isis] silent-interface Vlan-interface 3
To Next Page
Loading...
