Huawei Quidway S8500 Series - Chapter 3 Device Management Commands

Command Manual – System Management
Quidway S8500 Series Routing Switches Chapter 3 Device Management Commands
Huawei Technologies Proprietary
3-1
Chapter 3 Device Management Commands
3.1.1 boot boot-loader
Syntax
boot boot-loader { primary | backup } file-url [ slot slot-number ]
View
User view
Parameter
file-url: ARP program path + program name
slot-number: Slot number of the active or standby SRPC.
primary: Specifies this program to be the primary bootstrap program.
backup: Specifies this program to be the backup bootstrap program.
Description
Use the boot boot-loader primary command to specify the primary bootstrap program
to be the bootstrap program.
Use the boot boot-loader backup command to specify the backup bootstrap program
to be the bootstrap program.
If the switch cannot be started through specified bootstrap program, a program will be
selected from the Flash or CF card as bootstrap program. If the switch still cannot be
started normally, the switch fails to boot up.
 Note:
An S8500 series routing switch supports system switchover, both its active and
standby SRPCs have an application program system. You can operate on the
programs on both SRPCs. But when you specify a bootstrap program on the standby
SRPC, the URL of the program must begin with "slot[No.]#[flash: | cf:]/", where, [No.] is
the slot number of the standby SRPC and [flash: | cf:] is the name of the equipment,
flash card or CF card. For example, if the slot number of the standby SRPC is 1, the
URL of the 8500.app program under the root directory on the standby SRPC must be
"slot1#flash:/8500.app".