Command Manual – Port
Quidway S8500 Series Routing Switches Chapter 1 Ethernet Port Configuration Commands
Huawei Technologies Proprietary
1-11
Description
Use the link-status hold hold-time command to set port hold time. If the Down/Up
operation is implemented on ports too frequently, the switch may fail. Therefore, the
function is provided to prohibit frequent change of the port status.
Use the undo link-status hold command to restore the default port hold time, 3
seconds.
Related command: display interface.
Example
# Set the port hold time to 5 seconds.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] link-status hold 5
1.1.11 interface
Syntax
interface interface-type interface-number
View
System view
Parameter
interface-type: Specifies the port type. It can be Aux, Ethernet, Loopback, M-Ethernet,
NULL, VLAN-interface, GigabitEthernet and 10-GigabitEthernet, Pos, RPR.
interface-number: Specifies the port number. It adopts slot-number/subslot-number/
port-number format. slot-number specifies the LPU slot number of the port. For S8505,
it ranges from 2 to 6. For S8508, it ranges from 0 to 3 and 6 to 9 (slot number 4 and 5
are SRPU). For S8512, it ranges from 0 to 5 and 8 to 13 (slot number 6 and 7 are
SRPU). subslot-number specifies the sub-slot number of the port and ranges from 1 to
3. port-number specifies the port number on the daughter card. It is 1 or ranges from 1
to 12, 20, or 48, depending on the service board type. M-Ethernet is used to update and
maintain. It ranges from 0/0/0.
Description
Use the interface command to enter various types of Ethernet port views.
Before you can configure the related parameters of a type of Ethernet port, you must
first use this command to enter the Ethernet port view of this type.
To Next Page
Loading...
Need help?
General