Huawei Quidway S8500 Series User Manual

Command Manual – Routing Protocol
Quidway S8500 Series Routing Switches Chapter 4 Integrated IS-IS Configuration Commands
Huawei Technologies Proprietary
4-27
Description
Use the timer lsp-generaion command to set the time interval to generate LSPs (link
state packets).
Use the undo timer lsp-generation command to restore the default setting.
When an event occurs, a new LSP needs to be generated for the IS-IS protocol. But the
frequent generation of LSPs will result in the occupancy of huge resources and thus
decrease the performance of the routing switch. To avoid the great decrease of the
performance, an exponent decrement method is adopted for the generation of LSPs.
You can set the intervals to generate LSPs as required.
Example
# Set the intervals to generate LSPs to 10 500 2500.
[Quidway-isis] timer lsp-generation 10 500 2500
4.1.30 isis timer retransmit
Syntax
isis timer retransmit seconds
undo isis timer retransmit
View
Interface view
Parameter
seconds: Specifies the retransmission interval of LSP packets, in the unit of second, in
the range from 1 to 300 and the default value is five seconds.
Description
Use the isis timer retransmit command to configure the LSP retransmission interval
over the point-to-point link.
Use the undo isis timer retransmit command to restore the default setting.
Use caution when setting this parameter to avoid unnecessary retransmission.
The response is required when sending LSP packets on the point-to-point link, not the
broadcast link, and therefore this command is unnecessary for the broadcast link.
Related command: isis timer lsp.
Example
# Set the LSP retransmission interval to 10 seconds on Interface Vlan-interface 10.
[Quidway] interface Vlan-interface 10
[Quidway-Vlan-interface10] isis timer retransmit 10

Huawei Quidway S8500 Series Specifications

General

Brand	Huawei
Model	Quidway S8500 Series
Category	Switch
Language	English