Huawei Quidway S8500 Series - Igmp Host-Join Port; Igmp Host-Join Vlan

Command Manual – Multicast Protocol
Quidway S8500 Series Routing Switches Chapter 4 IGMP Configuration Commands
Huawei Technologies Proprietary
4-9
4.1.8 igmp host-join port
Syntax
igmp host-join group-address port interface-type interface- number [ to
{ interface-type interface- number ]
undo igmp host-join group-address port { interface-type interface-number [ to
{ interface-type interface- number ]
View
VLAN interface view
Parameter
group-address: Multicast address of the multicast group that an interface will join.
interface-type interface-number [ to interface-type interface-number ]: Specifies the
port under the VLAN interface.
Description
Use the igmp host-join command to enable a port in the VLAN interface of an Ethernet
switch to join a multicast group.
Use the undo igmp host-join command to disable the configuration.
By default, an interface does not join any multicast group.
Related command: igmp group-policy.
Example
# Add port Ethernet 2/1/1 under VLAN-interface10 to the multicast group 225.0.0.1.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway]interface vlan-interface 10
[Quidway-Vlan-interface10] igmp host-join 225.0.0.1 port Ethernet 2/1/1
4.1.9 igmp host-join vlan
Syntax
igmp host-join group-address vlan vlan-id
undo igmp host-join group-address vlan vlan-id
View
Ethernet port view