Command Manual – Multicast Protocol
Quidway S8500 Series Routing Switches Chapter 1 IGMP Snooping Configuration Commands
Huawei Technologies Proprietary
1-14
Caution:
z You will fail to configure a port to be a static routing port if the port identified by the
port-number argument does not exist or does not belong to the VLAN.
z You can configure multiple ports in a VLAN to be static routing ports by executing
the igmp-snooping mrouter port command repeatedly. The newly configured
ports do not replace the existing static routing ports.
z The configuration of a static routing port takes effect on the current port only, no
matter whether the current port is an aggregated port or not. To configure all ports in
an aggregation group as static routing ports, you can enable the static routing port
function on all the ports in the aggregation group.
Related command: igmp-snooping mrouter vlan.
Example
# Configure GigabitEthernet 5/1/1 port to be a static routing port (assuming that
GigabitEthernet 5/1/1 port belongs to VLAN 1).
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] vlan 10
[Quidway-vlan10] igmp-snooping mrouter port GigabitEthernet 5/1/1
# Cancel the static routing port GigabitEthernet 5/1/1 port in VLAN10.
[Quidway-vlan10] undo igmp-snooping mrouter port GigabitEthernet 5/1/1
1.2.2 igmp-snooping mrouter vlan
Syntax
igmp-snooping mrouter vlan vlan-id
undo igmp-snooping mrouter vlan vlan-id
View
Ethernet port view
Parameter
vlan-id: ID of the VLAN to which the static routing port belongs.
To Next Page
Loading...
