Command Manual – Multicast Protocol
Quidway S8500 Series Routing Switches Chapter 5 PIM Configuration Commands
Huawei Technologies Proprietary
5-14
Description
Use the pim command to enter the PIM view and configure the PIM global parameters.
Note that the command does not enable the PIM protocol.
Use the undo pim command to return to system view, clear the PIM global parameters
configured before and clear the PIM view.
Example
# Enter the PIM view.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] multicast routing-enable
[Quidway] pim
[Quidway-pim]
5.1.14 pim bsr-boundary
Syntax
pim bsr-boundary
undo pim bsr-boundary
View
VLAN interface view
Parameter
None
Description
Use the pim bsr-boundary command to configure an interface to be the PIM domain
border.
Use the undo pim bsr-boundary command to remove the border.
By default, no domain border is set.
You can use this command to set border of bootstrap messages, that is to say,
bootstrap messages cannot pass interfaces that are configured with pim
bsr-boundary command while other PIM messages can. In this way, the network is
divided into different BSR domains. Each domain uses a different bootstrap router.