Huawei Quidway S8500 Series User Manual

Command Manual – Port
Quidway S8500 Series Routing Switches Chapter 4 RPR Port Configuration Commands
Huawei Technologies Proprietary
4-23
Parameter
non-revertive: Sets the protection reversion mode to non-revertive. After the WTR
timer times out, the service cannot be restored till others request high priority protection
in the ring.
revertive: Sets the protection reversion mode to revertive. After the WTR timer times
out, the service can be restored at once.
Description
Use the rpr reversion-mode command to set the protection reversion mode.
Use the undo rpr reversion-mode command to restore the default mode.
The default RPR protection reversion mode is revertive.
Example
# Set RPR protection reversion mode to non-revertive.
<Quidway> system-view
[Quidway] interface RPR2/1/1
[Quidway-RPR2/1/1] rpr reversion-mode non-revertive
4.1.22 rpr static-rs
Syntax
rpr static-rs { mac-address } { ringlet0 | ringlet1 }
undo rpr static-rs { mac-address }
View
RPR logical port view
Parameter
mac-address: MAC address of destination node.
ringlet0: Transports packets to the specified node over Ringlet0.
ringlet1: Transports packets to the specified node over Ringlet1.
Description
Use the rpr static-rs command to configure static ring selection information and force
the RPR ring to transmit packets to the specified node. You can configure them
according to the IP address or MAC address of the destination node.
Use the undo rpr static-rs command to remove the configuration. If no parameter is
selected, the command removes all static configurations.
By default, the static ring selection information is not configured.

Huawei Quidway S8500 Series Specifications

General

Brand	Huawei
Model	Quidway S8500 Series
Category	Switch
Language	English