Command Manual – VLAN&QinQ
Quidway S8500 Series Routing Switches Chapter 1
VLAN Configuration Commands
Huawei Technologies Proprietary
1-7
[Quidway-vlan2] trap-to-cpu disable
Warning : CPU port will exit the designated VLAN.
Broadcast & multicast packets cannot forward to CPU!
1.1.9 trap-to-cpu disable vlan
Syntax
trap-to-cpu disable vlan { vlan-list | all }
undo trap-to-cpu disable vlan { vlan-list | all }
View
System view
Parameter
vlan-list: Specifies the list of VLANs that contain a CPU port, expressed in form of
vlan-list = { vlan-id [ to vlan-id ] } &<1-10>. The vlan-id before the keyword to must be
larger than or equal to the vlan-id after to. &<1-10> means that the preceding
parameter can be repeated up to 10 times.
I. all: All VLANs.
Description
II. Use the trap-to-cpu disable vlan command to move the CPU port out of the
specified VLANs.
III. Use the undo trap-to-cpu disable vlan command to move the CPU port into
the specified VLANs.
Example
# Move the CPU port out of VLAN 5 and VLANs 20 to 30.
[Quidway] trap-to-cpu disable vlan 5 20 to 30
1.1.10 vlan
Syntax
vlan vlan-id-list
undo vlan { vlan-id [ to vlan-id ] | all }
View
System view
To Next Page
Loading...
Need help?
General