Huawei Quidway S8500 Series User Manual

Command Manual – Routing Protocol
Quidway S8500 Series Routing Switches Chapter 3 OSPF Configuration Commands
Huawei Technologies Proprietary
3-45
Description
Use the ospf timer hello command to configure the interval for transmitting Hello
packets on an interface.
Use the undo ospf timer hello command to restore the interval to the default value.
By default, the interval is 10 seconds for an interface of p2p or broadcast type to
transmit Hello packets, and 30 seconds for an interface of nbma or p2mp type.
Related command: ospf timer dead.
Example
# Configure the interval for transmitting Hello packets on the interface Vlan-interface 10
to 20 seconds.
[Quidway] interface Vlan-interface 10
[Quidway-Vlan-interface10] ospf timer hello 20
3.1.45 ospf timer poll
Syntax
ospf timer poll seconds
undo ospf timer poll
View
Interface view
Parameter
seconds: Specifies the poll Hello interval, ranging from 1 to 65,535 and measured in
seconds. The default value is 120 seconds.
Description
Use the ospf timer poll command to configure the poll Hello packet interval on an
NBMA or p2mp network.
Use the undo ospf timer poll command to restore the default poll interval.
On an NBMA or p2mp network, if a neighbor is invalid, the Hello packet will be
transmitted regularly according to the poll seconds. You can configure the poll
seconds to specify how often the interface transmits Hello packet before it establishes
adjacency with the adjacent router. Poll seconds should be no less than three times of
Hello.
Example
# Configure to transmit poll Hello packets from interface Vlan-interface 20 every 130
seconds.

Huawei Quidway S8500 Series Specifications

General

Brand	Huawei
Model	Quidway S8500 Series
Category	Switch
Language	English