Huawei Quidway S8500 Series - Page 1227

Command Manual – NAT&URPF&VPLS
Quidway S8500 Series Routing Switches Chapter 3
VPLS Configuration Commands
Huawei Technologies Proprietary
3-4
local: Local PE.
vsi-name: Name of a VPLS instance, whose VPLS MAC forwarding entries will be
displayed.
dynamic: Displays only dynamic VPLS MAC forwarding entries.
static: Displays only static VPLS MAC forwarding entries.
count: Displays only the number of the VPLS MAC forwarding entries.
Description
Use the display mac-address vsi command to display the layer 2 VPLS forwarding
information. You can view the forwarding entry information of all VPLS instances or one
specific VPLS instance.
Related command: vsi, mac-address static.
Example
# View the forwarding entries of the VPLS instance Huawei.
[Quidway] display mac-address vsi Huawei
MAC ADDR STATE VPN ID PEER IP AGING TIME
0004-0000-005b dynamic 150 LOCAL AGING
--- 1 mac address(es) found ---
3.1.6 display mpls l2vc
Syntax
display mpls l2vc [ verbose | interface Vlan-interface interface-num } | { [ vsi
vsi-name ] [ peer peer-ip ] [ up | down | block ] }]
View
Any view
Parameter
verbose: Displays details about all layer 2 virtual connections (L2VCs).
Interface Vlan-interface: Displays information about the virtual connections
corresponding to the VSIs bound to the specified VLAN interface.
interface-num: Interface number of the specified VLAN interface.
vsi: Displays the L2VC information of the specified VSI.
vsi-name: Name of a VPLS instance, whose L2VC information will be displayed.
peer: Displays the information about L2VC to the specified peer PE.
peer-ip: IP address of a peer PE.
up: Displays the information about L2VC in Up state.