Huawei Quidway S8500 Series User Manual

Command Manual – System Management
Quidway S8500 Series Routing Switches Chapter 7 NTP Configuration Commands
Huawei Technologies Proprietary
7-3
Parameter
None
Description
Use the display ntp-service status command to display the NTP service status.
Example
# Display the NTP service status.
<Quidway> display ntp-service status
clock status: unsynchronized
clock stratum: 16
reference clock ID: none
nominal frequency: 100.0000 Hz
actual frequency: 100.0000 Hz
clock precision: 2^17
clock offset: 0.0000 ms
root delay: 0.00 ms
root dispersion: 0.00 ms
peer dispersion: 0.00 ms
reference time: 00:00:00.000 UTC Jan 1 1900(00000000.00000000)
The following table describes the outputs:
Table 7-1 Description on the fields of the display ntp-service status command
Field Description
clock status:
unsynchronized
Local clock status: do not synchronize to any remote NTP
server.
clock stratum: 16 Indicates the NTP stratum of local clock.
reference clock ID
Indicates the address of a remote server of the reference ID, in
the case that the local system has been synchronized by a
remote NTP server or the ID of some clock source.
nominal frequency Nominal frequency of the local system hardware clock
actual frequency Actual frequency of the local system hardware clock
clock precision Precision of local system clock
clock offset Offset of the local clock to the NTP server clock
root delay Root delay from local equipment to the master reference clock.
root dispersion Dispersion of the local clock relative to the NTP server clock
peer dispersion Dispersion of the remote NTP server
reference time Reference timestamp

Huawei Quidway S8500 Series Specifications

General

Brand	Huawei
Model	Quidway S8500 Series
Category	Switch
Language	English