Huawei Quidway S8500 Series - Page 1231

Command Manual – NAT&URPF&VPLS
Quidway S8500 Series Routing Switches Chapter 3
VPLS Configuration Commands
Huawei Technologies Proprietary
3-8
3.1.9 mac-address
Syntax
mac-address { static H-H-H } vsi vsi-name { peer peer-ip | vlan-interface
vlan-interface-number }
undo mac-address { static H-H-H } vsi vsi-name
View
System view
Parameter
static: Specifies a static MAC address. Only static VSI MAC addresses are allowed at
present.
H-H-H: Value of the static MAC address.
vsi: Specifies a VSI name.
vsi-name: Name of a VPLS instance.
peer: Specifies the virtual connection peer of the static MAC address.
peer-ip: IP address of the virtual connection peer of the static MAC address.
vlan-interface: The VLAN interface that is bound to corresponding local VSI of the
specified static MAC address.
vlan-interface-number: The number of the specified VLAN interface
Description
Use the mac-address command to configure a static MAC address for a VPLS
instance. The address you configured can be either a MAC address on a local CE or a
MAC address on a remote CE.
Use the undo mac-address command to disable the configuration.
Note that when configuring the static MAC address of a VPLS instance with the peer
keyword specified, if the VLAN-interface is specified, the command configures the
MAC address of the corresponding VLAN interface which is bound to a local CE.
Related command: vsi, display mac-address vsi.
Example
# Configure static MAC address entries for a local CE and a CE connecting to a remote
peer PE of the VPLS instance Huawei and bind VLAN interface 10 to the local CE of
VPLS instance Huawei.
[Quidway] mac-address static 0000-fc39-a9b5 vsi Huawei vlan-interface 10
[Quidway] mac-address static 0000-fc39-a9b4 vsi Huawei peer 2.2.2.2