Huawei Quidway S8500 Series - Page 1276

Command Manual – Integrated Management
Quidway S8500 Series Routing Switches Chapter 1
HGMP V1 Configuration Commands
Huawei Technologies Proprietary
1-36
Syntax
query link-aggregation
View
lanswitch view
Parameter
None
Description
Use the query link-aggregation command to display information about port
aggregation of the Ethernet switch.
If you have configured port aggregation on the Ethernet switch, this command displays
the port aggregation settings, including port numbers; if you have not configured port
aggregation, the command displays “—”.
Related command: set link-aggregation.
Example
# Query information about port aggregation of the Ethernet switch with a position
parameter of 3/1/6-/.
[Quidway-lanswitch3/1/6-/] query link-aggregation
Waiting.....
--------------------Link-aggregation Group-------------------
Lk-ag Num Type Port1 port2 port3 port4
- - - - - -
----------------------End--------------------------
Waiting.....
--------------------Link-aggregation Group-------------------
Link-aggregation Num Type Port1 port2 port3 port4
0 sa 1 2 3 4
----------------------End--------------------------
Table 1-9 Description on the fields of the query link-aggregation command
Field Description
Link-aggregation Num Port aggregation group number
Type Aggregation type (sa or dasa)
Port1 port2 port3 port4
Port numbers of the aggregated ports. As for
low-end Ethernet switches, each aggregation
group can contain up to four ports