Huawei Quidway S8500 Series - Page 286

Command Manual – Routing Protocol
Quidway S8500 Series Routing Switches Chapter 1 Static Route Configuration Commands
Huawei Technologies Proprietary
1-3
Description
Use the display ip routing-table acl command to view the route filtered through
specified basic access control list (ACL).
This command is used in track display of route policy to display the route that passed
the filtering rule according the input basic ACL number or name.
The command is only applicable to display the route that passed basic ACL filtering
rules.
Example
# Display the summary of Active routes that are filtered through basic acl 2000.
[Quidway] acl number 2000
[Quidway-acl-basic-2000] rule permit source 10.1.1.1 0.0.0.255
[Quidway-acl-basic-2000] rule deny source any
[Quidway-acl-basic-2000] display ip routing-table acl 2000
Routes matched by access-list 2000:
Summary count: 4
Destination/Mask Protocol Pre Cost Nexthop Interface
10.1.1.0/24 DIRECT 0 0 10.1.1.2 Vlan-interface1
10.1.1.2/32 DIRECT 0 0 127.0.0.1 InLoopBack0
For detailed description of the output information, see Table 1-1.
# Display the verbose information of the Active and Inactive routes that are filtered
through basic acl 2000.
<Quidway> display ip routing-table acl 2000 verbose
Routes matched by access-list 2000:
+ = Active Route, - = Last Active, # = Both * = Next hop in use
Summary count: 2
**Destination: 10.1.1.0 Mask: 255.255.255.0
Protocol: #DIRECT Preference: 0
*NextHop: 10.1.1.2 Interface: 10.1.1.2(Vlan-interface1)
Vlinkindex: 0
State: <Int ActiveU Retain Unicast>
Age: 7:24 Cost: 0/0 Tag: 0
**Destination: 10.1.1.2 Mask: 255.255.255.255
Protocol: #DIRECT Preference: 0
*NextHop: 127.0.0.1 Interface: 127.0.0.1(InLoopBack0)
Vlinkindex: 0
State: <NoAdvise Int ActiveU Retain Gateway Unicast>