Command Manual – Routing Protocol
Quidway S8500 Series Routing Switches Chapter 3 OSPF Configuration Commands
Huawei Technologies Proprietary
3-20
Parameter
process-id: Process ID of OSPF. The command is applied to all current OSPF
processes if you do not specify a process ID.
interface-type interface-number: Specifies an interface.
Description
Use the display ospf interface command to view the OSPF interface information.
Example
# Display the OSPF interface information of Vlan-interface1.
<Quidway> display ospf interface vlan-interface 1
OSPF Process 1 with Router ID 1.1.1.1
Interfaces
Interface: 10.110.10.2 (Vlan-interface1)
Cost: 1 State: BackupDR Type: Broadcast
Priority: 1
Designated Router: 10.110.10.1
Backup Designated Router: 10.110.10.2
Timers: Hello 10, Dead 40, Poll 0, Retransmit 5, Transmit Delay 1
Table 3-6 Description of the fields of the display ospf interface command
Field Description
Cost Cost of the interface
State State of the interface state machine
Type Network type of OSPF on the interface
Priority Priority of the interface for DR election in its network
Designated Router DR on the network in which the interface resides
Backup Designated Router BDR on the network in which the interface resides
OSPF timers, defining as follows:
Hello Interval of Hello packet
Dead Interval of dead neighbors
Poll Interval of poll
Timers
Retransmit Interval of retransmitting LSA
Transmit Delay Delay time of transmitting LSA
To Next Page
Loading...
Need help?
General