Command Manual – Multicast Protocol
Quidway S8500 Series Routing Switches Chapter 3 Multicast Common Configuration Commands
Huawei Technologies Proprietary
3-18
Parameter
all: All route entries in the core multicast routing table.
group-address: Specifies multicast group address.
group-mask: Specifies Mask of multicast group address
group-mask-length: Specifies mask length of multicast group address.
source-address: Specifies source address.
source-mask: Specifies mask of source address.
source-mask-length: Specifies mask length of source address.
incoming-interface: Specifies incoming interface for the multicast forward entry.
vlan-interface-type interface-number: Interface type and VLAN virtual interface
number.
Description
Use the reset multicast routing-table command to clear route entries from the core
multicast routing table, as well as MFC forwarding entries.
You can type in source address first and group address after in the command, as long
as they both are valid addresses. The system prompts error information if you type in
invalid addresses.
Related command: reset pim routing-table, reset multicast forwarding-table and
display multicast forwarding-table.
Example
# Clear the route entry with address of 225.5.4.3 from the core multicast routing table.
<Quidway> reset multicast routing-table 225.5.4.3
To Next Page
Loading...
