Huawei Quidway S8500 Series - Page 576

Command Manual – Multicast Protocol
Quidway S8500 Series Routing Switches Chapter 6 MSDP Configuration Commands
Huawei Technologies Proprietary
6-4
Sending SA-Requests status: disable
Minimum TTL to forward SA with encapsulated data: 0
SAs learned from this peer: 0, SA-cache maximum for the peer: none
Input queue size: 0, Output queue size: 0
Counters for MSDP message:
Count of RPF check failure: 0
Incoming/outgoing SA messages: 0/0
Incoming/outgoing SA requests: 0/0
Incoming/outgoing SA responses: 0/0
Incoming/outgoing data packets: 0/0
6.1.5 display msdp sa-cache
Syntax
display msdp sa-cache [ group-address | source-address |
autonomous-system-number ]*
View
Any view
Parameter
group-address: Group address of (S, G) entry.
source-address: Source address of (S, G) entry. With no source address specified, all
the source information of the specified group will be displayed.
If neither group address nor source address is determined, all SA caches will be
displayed.
autonomous-system-number: Displays (S, G) entries from specified autonomous
system.
Description
Use the display msdp sa-cache command to view (S, G) state learnt from MSDP
peer.
Only cache-sa-enable command is configured, can cache state be displayed.
Example
# Display the (S, G) state learned from MSDP peer.
<Quidway> display msdp sa-cache
MSDP Total Source-Active Cache - 5 entries
(Source, Group) Origin RP Pro AS Uptime Expires
(10.10.1.2, 225.1.1.1) 10.10.10.10 BGP 100 00:00:10 00:05:50