Command Manual – QoS/ACL
Quidway S8500 Series Routing Switches Chapter 1 ACL Commands
Huawei Technologies Proprietary
1-7
A delay, about one minute, exists in system’s updating ACLs, but the result of the
display time-range command is based on the current time. Then there may the case
where a time range have been shown active using the display time-range command,
while it is still inactive in importing the ACL. You just take it as a normal case.
Related command: time-range.
Example
# Display all time ranges.
<Quidway> display time-range all
Current time is 14:36:36 4-3-2003 Thursday
Time-range : hhy ( Inactive )
from 08:30 2-5-2005 to 18:00 2-19-2005
Time-range : hhy1 ( Inactive )
from 08:30 2-5-2003 to 18:00 2-19-2003
Table 1-2 Description of displayed information
Field Description
Current time is 14:36:36
4-3-2003 Thursday
The current time of the system
Time-range : hhy ( Inactive )
from 08:30 2-5-2005 to 18:00
2-19-2005
Time range hhy. “Inactive” means that the time
range is inactive currently (active means the time
range is active), and the time range is from 08:30
2-5-2005 to 18:00 2-19-2005
The displayed information below is similar.
# Display time range tm1.
<Quidway> display time-range tm1
Current time is 14:37:31 4-3-2003 Thursday
Time-range : tm1 ( Inactive )
from 08:30 2-5-2005 to 18:00 2-19-2005
To Next Page
Loading...
Need help?
General