Huawei Quidway S8500 Series - Page 746

Command Manual – MPLS
Quidway S8500 Series Routing Switches Chapter 2 BGP/MPLS VPN Configuration Commands
Huawei Technologies Proprietary
2-8
2.1.9 display ip routing-table vpn-instance
Syntax
display ip routing-table vpn-instance vpn-instance-name [ [ ip-address ] | [ verbose ]
statistics ]
View
Any view
Parameter
vpn-instance-name: Name assigned to VPN-instance.
ip-address: Displays information of the a specified address.
statistics: Displays statistics of routes.
verbose: Displays detailed information.
Description
Use the display ip routing-table VPN-instance command to view the specified
information in the IP routing table of vpn-instance.
Example
# Display the IP routing table associated with the VPN-instance.
<PEA> disp ip routing-table vpn-instance vpna-ce1
vpna-ce1 Route Information
Routing Table: vpna-ce1 Route-Distinguisher: 100:1
Destination/Mask Protocol Pre Cost Nexthop Interface
20.20.20.0/24 BGP 256 0 40.40.40.40 Vlan-interface24
40.40.40.0/24 DIRECT 0 0 40.40.40.10 Vlan-interface24
40.40.40.10/32 DIRECT 0 0 127.0.0.1 InLoopBack0
80.80.80.0/24 BGP 256 0 40.40.40.40 Vlan-interface24
200.200.200.0/24 BGP 256 0 40.40.40.40 Vlan-interface24
VPN Routing Table: Route-Distinguisher: 100:2
20.20.20.0/24 BGP 256 0 2.2.2.2
InLoopBack0
30.30.30.0/24 BGP 256 0 2.2.2.2
InLoopBack0
2.1.10 display ip vpn-instance
Syntax
display ip vpn-instance [ vpn-instance-name | verbose ]