Huawei Quidway S8500 Series - Page 748

Command Manual – MPLS
Quidway S8500 Series Routing Switches Chapter 2 BGP/MPLS VPN Configuration Commands
Huawei Technologies Proprietary
2-10
Example
# Display MPLS L3VPN transit lsp information on the ASBR.
<Quidway> display mpls l3vpn-lsp transit
-----------------------------------------------------------------------
LSP Information: Ebgp Transit Lsp
-----------------------------------------------------------------------
NO I/O-LABEL NEXTHOP IN-INTERFACE OUT-INTERFACE
1 1025/3 30.30.1.2 ------- Vlan20
2 1024/3 10.10.1.2 ------- Vlan10
3 1026/1024 30.30.1.2 ------- Vlan20
TOTAL: 3 Record(s) Found.
Table 2-2 Description of the command information on display
Field Description
NO Number
I/O-LABEL
Incoming/Outgoing label. VPN labels (labels advertised with
VPNV4 routes) will be displayed in case of uni-hop EBGP
cross-AS MPLS L3 VPN networking, and tunneling labels
(labels advertised with unicast routes and labels advertised by
LDP protocol) will be displayed in case of multi-hop EBGP
cross-AS MPLS L3 VPN networking.
NEXTHOP Next hop
IN-INTERFACE Ingress interface
OUT-INTERFACE Egress interface
# Display MPLS L3VPN ingress lsp information on PE (Provider Edge).
<Quidway> display mpls l3vpn-lsp ingress
-----------------------------------------------------------------------
LSP Information: L3vpn Ingress Lsp
-----------------------------------------------------------------------
Vpn-instance Name: vpna Route Distinguisher: 100:1
NO FEC NEXTHOP OUTER-LABEL OUT-INTERFACE
1 168.3.1.0/24 10.10.1.1 1026(vpn) Vlan10
TOTAL: 1 Record(s) Found.