Command Manual – MPLS
Quidway S8500 Series Routing Switches Chapter 3 MPLS L2VPN Configuration Commands
Huawei Technologies Proprietary
3-13
local-ce: Displays the state and configuration of the local CE of a specified VPN
instance.
remote-ce: Displays the state and configuration of the remote CE of a specified VPN
instance.
down: Displays the information about L2VPN whose CE interfaces are Down.
remote-ce: Displays the state and configuration of the remote CE.
up: Displays the information L2VPN whose CE interfaces are Up.
verbose: Displays detailed information about the CE interfaces.
brief: Displays the summary information about a specified connection.
Interface: Displays information about a specified CE interface.
vlan-id: ID of the VLAN whose interface is used to create the connection.
vc-label: VC label.
interface-type: Type of the interface, which can be Aux, Ethernet, LoopBack,
M-Ethernet, NULL, Vlan-interface, GigabitEthernet; or 10-GigabitEthernet, Pos, and
RPR.
Description
Use the display mpls l2vpn command to display the MPLS L2VPN information. The
command can display the state and configuration of the local/remote CE of a specified
VPN instance, and the L2VPN information about a specified CE interface.
Example
# Display the L2VPN information about a specified interface.
[DEV-UP] dis mpls l2vpn forwarding-info 10241 interface Vlan-interface 300
VCLABEL TUNNELTYPE ENTRYTYPE OUTINTERFACE OUTSLOT TOKEN CTRLWORD
--------------------------------------------------------------------------
------
10241 LSP SEND Vlan-interface100 0 0 FA
LSE
1 Record(s) Found.
[DEV-UP]dis mpls l2vpn connection interface Vlan-interface 300
conn-type: remote, local vc state: up, remote vc state: up,
Local ce-id: 1, local ce name: ce1, remote ce-id: 2,
intf(state,encap): Vlan-interface300(up,ethernet),
peer id: 2.2.2.2, route-distinguisher: 100:1,
local vc label: 10242, remote vc label: 10241,
tunnel type: LSP, tunnel val: 0
To Next Page
Loading...
Need help?
General