Command Manual – Port
Quidway S8500 Series Routing Switches
Chapter 2 Ethernet Link Aggregation Configuration
Commands
Huawei Technologies Proprietary
2-6
Parameter
agg-id: Aggregation group ID, which must be existing ones, in the range of 1 to 920. IDs
1 through 31 indicate manual or static aggregation groups; IDs 32 through 64 are
reserved; IDs 65 through 192 are Routed Trunks; IDs 193 through 920 indicate
dynamic aggregation groups.
Description
Use the display link-aggregation verbose command to view detailed information of a
designated port, including aggregation group ID, aggregation group type, load sharing
type, aggregation group description and detailed local information (system ID, member
ports, port status, port priority, flag, operation key, link status) and detailed remote
information (local port, indexes of remote ports, port priority, flag, operation key and
system ID, here local and remote are in a relative sense).
Note that since the manual aggregation group cannot get the information of the peer
end, every item of the peer end is displayed as 0, which does not indicate the actual
status of the peer system.
Example
# Display the detailed information of aggregation group 5.
<Quidway> display link-aggregation verbose 5
Loadsharing Type: Shar -- Loadsharing, NonS -- Non-Loadsharing
Aggregation ID: 5, AggregationType: Manual, Loadsharing Type: Shar
Aggregation Description:
System ID: 0x0, 00e0-fc00-1312
Port Status: S -- Selected, T -- sTandby, U -- Unselected
Local:
Port Status Priority Flag Oper-Key Link-Status
--------------------------------------------------------------------------
------
Ethernet9/1/9 S 32768 0x00 8 Down
Ethernet9/1/10 S 32768 0x00 8 Down
Remote:
Actor Partner Priority Flag Oper-Key SystemID
--------------------------------------------------------------------------
------
Ethernet9/1/9 0 0 0x00 0 0x0,0000-0000-0000
Ethernet9/1/10 0 0 0x00 0 0x0,0000-0000-0000
To Next Page
Loading...
Need help?
General