www.ti.com
Registers
1291
SPRUH91D–March 2013–Revised September 2016
Submit Documentation Feedback
Copyright © 2013–2016, Texas Instruments Incorporated
Universal Asynchronous Receiver/Transmitter (UART)
29.3.13 Power and Emulation Management Register (PWREMU_MGMT)
The power and emulation management register (PWREMU_MGMT) is shown in Figure 29-23 and
described in Table 29-24.
Figure 29-23. Power and Emulation Management Register (PWREMU_MGMT)
31 16
Reserved
R-0
15 14 13 12 1 0
Rsvd UTRST URRST Reserved FREE
R/W-0 R/W-0 R/W-0 R-1 R/W-0
LEGEND: R/W = Read/Write; R = Read only; -n = value after reset
Table 29-24. Power and Emulation Management Register (PWREMU_MGMT) Field Descriptions
Bit Field Value Description
31-16 Reserved 0 Reserved
15 Reserved 0 Reserved. This bit must always be written with a 0.
14 UTRST UART transmitter reset. Resets and enables the transmitter.
0 Transmitter is disabled and in reset state.
1 Transmitter is enabled.
13 URRST UART receiver reset. Resets and enables the receiver.
0 Receiver is disabled and in reset state.
1 Receiver is enabled.
12-1 Reserved 1 Reserved
0 FREE Free-running enable mode bit. This bit determines the emulation mode functionality of the UART. When
halted, the UART can handle register read/write requests, but does not generate any
transmission/reception, interrupts or events.
0 If a transmission is not in progress, the UART halts immediately. If a transmission is in progress, the
UART halts after completion of the one-word transmission.
1 Free-running mode is enabled; UART continues to run normally.
To Next Page