Texas Instruments TMS320C6745 DSP - MDIO User Command Complete Interrupt (Unmasked) Register (USERINTRAW); MDIO User Command Complete Interrupt (Unmasked) Register (USERINTRAW) Field Descriptions

Registers www.ti.com
636
SPRUH91D–March 2013–Revised September 2016
Submit Documentation Feedback
Copyright © 2013–2016, Texas Instruments Incorporated
EMAC/MDIO Module
17.3.2.7 MDIO User Command Complete Interrupt (Unmasked) Register (USERINTRAW)
The MDIO user command complete interrupt (unmasked) register (USERINTRAW) is shown in
Figure 17-31 and described in Table 17-29.
Figure 17-31. MDIO User Command Complete Interrupt (Unmasked) Register (USERINTRAW)
31 16
Reserved
R-0
15 2 1 0
Reserved USERACCESS1 USERACCESS0
R-0 R/W1C-0 R/W1C-0
LEGEND: R/W = Read/Write; R = Read only; W1C = Write 1 to clear (writing a 0 has no effect); -n = value after reset
Table 17-29. MDIO User Command Complete Interrupt (Unmasked) Register (USERINTRAW)
Field Descriptions
Bit Field Value Description
31-2 Reserved 0 Reserved
1 USERACCESS1 MDIO User command complete event bit. When asserted, the bit indicates that the previously
scheduled PHY read or write command using the USERACCESS1 register has completed.
Writing a 1 will clear the event, writing a 0 has no effect.
0 No MDIO user command complete event.
1 The previously scheduled PHY read or write command using MDIO user access register
USERACCESS1 has completed.
0 USERACCESS0 MDIO User command complete event bit. When asserted, the bit indicates that the previously
scheduled PHY read or write command using the USERACCESS0 register has completed.
Writing a 1 will clear the event, writing a 0 has no effect.
0 No MDIO user command complete event.
1 The previously scheduled PHY read or write command using MDIO user access register
USERACCESS0 has completed.