Texas Instruments TMS320C6745 DSP - Revision ID Register (REVID); Revision ID Register (REVID) Field Descriptions

www.ti.com Registers
547
SPRUH91D–March 2013–Revised September 2016
Submit Documentation Feedback
Copyright © 2013–2016, Texas Instruments Incorporated
Enhanced Direct Memory Access (EDMA3) Controller
Table 16-61. EDMA3 Transfer Controller (EDMA3TC) Registers (continued)
Offset Acronym Register Description Section
3CCh DFDST3 Destination FIFO Destination Address Register 3 Section 16.4.3.6.16
3D0h DFBIDX3 Destination FIFO B-Index Register 3 Section 16.4.3.6.17
3D4h DFMPPRXY3 Destination FIFO Memory Protection Proxy Register 3 Section 16.4.3.6.18
16.4.3.1 Revision Identification Register (REVID)
The revision identification register (REVID) is a constant register that uniquely identifies the EDMA3TC
and specific revision of the EDMA3TC. The REVID is shown in Figure 16-82 and described in
Table 16-62.
Figure 16-82. Revision ID Register (REVID)
31 0
REV
R-4000 3B00h
LEGEND: R = Read only; -n = value after reset
Table 16-62. Revision ID Register (REVID) Field Descriptions
Bit Field Value Description
31-0 REV Peripheral identifier.
4000 3B00h Uniquely identifies the EDMA3TC and the specific revision of the EDMA3TC.