EasyManua.ls Logo

Texas Instruments TMS320C6745 DSP - 14.2.6 Dead-Band Generator (DB) Submodule; Dead-Band Generator Submodule; Dead-Band Generator Submodule Registers

Texas Instruments TMS320C6745 DSP
1472 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CTR = CMPB
CTR = CMPA
CTR_Dir
CTR = 0
CTR = PRD
Dead
Band
(DB)
Counter
Compare
(CC)
Action
Qualifier
(AQ)
EPWMxA
EPWMxB
CTR = CMPB
CTR = 0
EPWMxINT
EPWMxA
EPWMxB
TZ1
to TZn
CTR = CMPA
Time-Base
(TB)
CTR = PRD
CTR = 0
CTR_Dir
EPWMxSYNCI
EPWMxSYNCO
EPWMxTZINT
PWM-
chopper
(PC)
Event
Trigger
and
Interrupt
(ET)
Trip
Zone
(TZ)
GPIO
MUX
Interrupt
controller
Interrupt
controller
Architecture
www.ti.com
324
SPRUH91DMarch 2013Revised September 2016
Submit Documentation Feedback
Copyright © 2013–2016, Texas Instruments Incorporated
Enhanced High-Resolution Pulse-Width Modulator (eHRPWM)
14.2.6 Dead-Band Generator (DB) Submodule
Figure 14-28 illustrates the dead-band generator submodule within the ePWM module.
Figure 14-28. Dead-Band Generator Submodule
14.2.6.1 Purpose of the Dead-Band Submodule
The "Action-qualifier (AQ) Module" section discussed how it is possible to generate the required dead-
band by having full control over edge placement using both the CMPA and CMPB resources of the ePWM
module. However, if the more classical edge delay-based dead-band with polarity control is required, then
the dead-band generator submodule should be used.
The key functions of the dead-band generator submodule are:
Generating appropriate signal pairs (EPWMxA and EPWMxB) with dead-band relationship from a
single EPWMxA input
Programming signal pairs for:
Active high (AH)
Active low (AL)
Active high complementary (AHC)
Active low complementary (ALC)
Adding programmable delay to rising edges (RED)
Adding programmable delay to falling edges (FED)
Can be totally bypassed from the signal path (note dotted lines in diagram)
14.2.6.2 Controlling and Monitoring the Dead-Band Submodule
The dead-band generator submodule operation is controlled and monitored via the following registers:
Table 14-25. Dead-Band Generator Submodule Registers
Acronym Register Description Address Offset Shadowed
DBCTL Dead-Band Control Register 1Eh No
DBRED Dead-Band Rising Edge Delay Count Register 20h No
DBFED Dead-Band Falling Edge Delay Count Register 22h No

Table of Contents

Related product manuals