Huawei Quidway S8500 Series - Page 111

Command Manual – Port
Quidway S8500 Series Routing Switches Chapter 4 RPR Port Configuration Commands
Huawei Technologies Proprietary
4-4
- broadcasts, - multicasts, 0 pauses
Output: 0 output errors, - underruns, - buffer failures
0 aborts, 0 deferred, - collisions, 0 late collisions
- lost carrier, - no carrier
Receive Packet Peak Value Info: 0 bytes, happened at 09:47:02 4-9-2001
Transmit Packet Peak Value Info: 0 bytes, happened at 09:47:02 4-9-2001
# Display the status information of the RPR4/1/1.1 RPR physical port.
<Quidway> display interface RPR 4/1/1.1
Rpr physical interface: RprPos4/1/1.1
Current state DOWN
SDH alarm:
section layer: LOS
line layer:
path layer:
Overhead C2 J0 J1
Rx 0xdf quidway quidway
Tx 0x16 quidway quidway
SDH error:
section layer: B1 0
line layer: B2 0
M1 0
path layer: B3 0
G1 0
Data Traffic Counters of the Interface: RprPos4/1/1.1
Host receive Packets Bytes
unicast 0 0
multicast 0 0
Line receive Packets Bytes
unicast 0 0
multicast 0 0
Host send Packets Bytes
unicast 0 0
multicast 0 0
Line send Packets Bytes
unicast 0 0
multicast 1 40
Input Errors
parity 0 short0 crc 0 ringiderr 0
Output Errors
parity 0 short0 giants0 fifo 0
Control Frame In Out