Huawei Quidway S8500 Series - Page 112

Command Manual – Port
Quidway S8500 Series Routing Switches Chapter 4 RPR Port Configuration Commands
Huawei Technologies Proprietary
4-5
Oam 0 0
Atd 0 1
Tc 0 496377
Tp 0 496378
Mode Packet Byte
SaStrip 0 0
TtlDrop 0 0
TxFlood 0 0
RxFlood 0 0
Table 4-1 Description on the fields of the display interface command
Field Description
RprPos4/1/1 current state Current RPRPOS port status
Including two physical rpr interface
RPRPOS port contains two physical
ports.
Rpr station name
Name of destination RPR node to be
detected
Rpr bridge MAC address MAC address of the RPR bridge
Rpr configured default ringlet Configured default ring ID
RPR work mode RPR operation mode
IP address of RPR Access VLAN's
interface
IP address of the VLAN virtual interface
to which an RPR port is bound
IP mask of RPR Access VLAN's
interface
IP subnet mask of the VLAN virtual
interface to which an RPR port is bound
Link-status hold interval Port hold time
Description Description information
The Maximum Transmit Unit The maximum transmit unit
10G speed mode and full duplex mode 10G mode and full duplex mode
Flow-control Flow control
The Maximum Frame Length The maximum frame length
Broadcast MAX-ratio
Broadcast storm suppression ratio on
the port
Allow jumbo frame to pass Allows jumbo frame to pass
PVID Default port VLAN ID
Port link-type Port link type
Tagged VLAN ID
Identifies the tagged packets in the
port’s VLANs