Huawei Quidway S8500 Series - Page 524

Command Manual – Multicast Protocol
Quidway S8500 Series Routing Switches Chapter 3 Multicast Common Configuration Commands
Huawei Technologies Proprietary
3-10
Caution:
You must use multicast routing-enable command in system view to enable IP
multicast routing before you can view the multicast routing table information.
Related command: display multicast forwarding-table
Example
# View the route entry information in the multicast routing table.
<Quidway> display multicast routing-table
Multicast Routing Table
Total 3 entries
(4.4.4.4, 224.2.149.17)
Uptime: 00:15:16, Timeout in 272 sec
Upstream interface: Vlan-interface1(4.4.4.6)
Downstream interface list:
Vlan-interface2(2.2.2.4), Protocol 0x1: IGMP
(4.4.4.4, 224.2.254.84)
Uptime: 00:15:16, Timeout in 272 sec
Upstream interface: Vlan-interface1(4.4.4.6)
Downstream interface list: NULL
(4.4.4.4, 239.255.2.2)
Uptime: 00:02:57, Timeout in 123 sec
Upstream interface: Vlan-interface1(4.4.4.6)
Downstream interface list: NULL
Matched 3 entries
The descriptions about the displayed information are shown in Table 3-4.
Table 3-4 Description of output information of the command display multicast
routing-table
Field Description
Multicast Routing Table Multicast routing table
Total 3 entries 3 entries in total
(4.4.4.4, 224.2.149.17) (s, g)