Huawei Quidway S8500 Series - Page 62

Command Manual – Port
Quidway S8500 Series Routing Switches Chapter 1 Ethernet Port Configuration Commands
Huawei Technologies Proprietary
1-6
The Maximum Frame Length is 1552
Broadcast MAX-ratio: 100%
Allow jumbo frame to pass
MixInsert-Port VPN status:not enable MixInsert access
PVID: 48
Mdi type: auto
Port link-type: access
Tagged VLAN ID : none
Untagged VLAN ID : 48
Last 300 seconds input: 0 packets/sec 61 bits/sec 1%
Last 300 seconds output: 0 packets/sec 0 bits/sec 1%
Input(total): 54 packets, 7465 bytes
42 broadcasts, 5 multicasts
Input(normal): 54 packets, 7465 bytes
- broadcasts, - multicasts
Input: 0 input errors, 0 runts, 0 giants, 0 throttles, 0 CRC
0 frame, 0 overruns, - aborts, 0 ignored, - parity errors
Output(total): 1 packets, 64 bytes
0 broadcasts, 0 multicasts, 0 pauses
Output(normal): 1 packets, 64 bytes
- broadcasts, - multicasts, 0 pauses
Output: 0 output errors, - underruns, - buffer failures
0 aborts, 0 deferred, - collisions, 0 late collisions
- lost carrier, - no carrier
Receive Packet Peak Value Info: 7215 bytes, happened at 03:30:35 3-7-2001
Transmit Packet Peak Value Info: 64 bytes, happened at 03:30:35 3-7-2001
Table 1-1 Description on the fields of the display interface command
Field Description
Ethernet2/1/1 current state
The current status of Ethernet port
(enabled or disabled)
IP Sending Frames' Format Ethernet frame format
Hardware address Port hardware address
The Maximum Transmit Unit Maximum transmit unit
Media type Type of media
loopback not set Port loopback test status
Port hardware type Port hardware type
100 Mbps-speed mode, full-duplex
mode
Link speed type is autonegotiation, link
duplex type is autonegotiation
Both the duplex mode and the rate are
set to auto-negotiation. The rate of 100
Mbps and the mode of full-duplex are
adopted after negotiating with its peer