Huawei Quidway S8500 Series - Page 63

Command Manual – Port
Quidway S8500 Series Routing Switches Chapter 1 Ethernet Port Configuration Commands
Huawei Technologies Proprietary
1-7
Field Description
Flow-control is not enabled Port flow control status
The Maximum Frame Length
Maximum length of the Ethernet frames
that can pass the port
Broadcast MAX-ratio Port broadcast storm suppression ratio
Allow jumbo frame to pass Jumbo frame is allowed to pass the port
Port VPN status
Port VPN status (enable or not VPN
access)
PVID Port default VLAN ID
Mdi type Cable type
Port link-type Port link type
Tagged VLAN ID The VLANs with packets tagged
Untagged VLAN ID The VLANs with packets untagged
Last 300 seconds input: 0 packets/sec 0
bits/sec
Last 300 seconds output: 0 packets/sec
0 bits/sec
The input/output rate and the passing
packet number on this port in the last
300 seconds.
Input(total): 0 packets, 0 bytes
0 broadcasts, 0 multicasts
Input(normal): 0 packets, 0 bytes
- broadcasts, - multicasts
Input: 0 input errors, 0 runts, 0 giants, 0
throttles, 0 CRC
0 frame, 0 overruns, - aborts, 0
ignored, - parity errors
Output(total): 0 packets, 0 bytes
0 broadcasts, 0 multicasts, 0
pauses
Output(normal): 0 packets, 0 bytes
- broadcasts, - multicasts, 0
pauses
Output: 0 output errors, - underruns, -
buffer failures
0 aborts, 0 deferred, - collisions, 0
late collisions
- lost carrier, - no carrier
The statistics information of input/output
packets and errors on this port. “-”
indicates that the item doesn’t supported
by the switch.