Huawei Quidway S8500 Series - Page 872

Command Manual – Security
Quidway S8500 Series Routing Switches Chapter 1
802.1x Configuration Commands
Huawei Technologies Proprietary
1-2
View
Any view
Parameter
enabled-interface: Configures to display the Ethernet port that starts Dot1x.
guest vlan: Displays Guest VLAN IDs and specifies the port that enables Guest VLAN.
interface: Configures to display the 802.1x information on the specified interface.
interface-list: Ethernet interface list expressed in the format interface-list
=interface-type interface-number [ to interface-type interface-number ] &<1-10>.
interface-type means the interface type, interface-number is the interface number.
Refer to command parameters in the “Port” section in the manual for the respective
meanings and value ranges of them. The interface number after the key word to should
be no smaller than the interface number before to. &<1-10> in the command means
that the preceding parameter can be entered up to 10 times.
sessions: Configures to display the session connection information of 802.1x.
statistics: Configures to display the relevant statistics information of 802.1x.
Description
Use display dot1x command to view the relevant information of 802.1x, including
configuration information, running state (session connection information) and relevant
statistics information.
By default, all the relevant 802.1x information about each interface will be displayed.
This command can be used to display the following information on the specified
interface: 802.1x configuration, state or statistics. If no port is specified when executing
this command, the system will display all 802.1x related information. For example,
802.1x configuration of all ports, 802.1x session connection information, and 802.1x
data statistical information. The output information of this command can help the user
to verify the current 802.1x configurations so as to troubleshoot 802.1x.
Related command: reset dot1x statistics, dot1x, dot1x retry, dot1x max-user,
dot1x port-control, dot1x port-method, dot1x timer.
Example
# Display the configuration information of 802.1x.
<Quidway> display dot1x
Equipment 802.1X protocol is enabled
CHAP authentication is enabled
DHCP-launch is disabled
Proxy trap checker is disabled
Proxy logoff checker is disabled