Registers
www.ti.com
954
SPRUH91D–March 2013–Revised September 2016
Submit Documentation Feedback
Copyright © 2013–2016, Texas Instruments Incorporated
Liquid Crystal Display Controller (LCDC)
23.3.3.5 Loaded Palette (PL)
The loaded palette (PL) bit is a read-only bit that is set after the LCD finished loading the palette into
memory.
• PL = 1 when the palette is loaded.
• PL = 0 as long as the palette is not loaded.
In data-only (PL = 10) and palette-plus-data (PL = 00) modes, write 0 to clear the interrupt. However, in
the palette only (PL = 01) mode, LCD must be turned off in order to reset/clear the interrupt. But in this
particular mode, make sure not to turn off the LCD before getting the loading interrupt.
To Next Page