Command Manual – System Management
Quidway S8500 Series Routing Switches Chapter 4 System Maintenance Commands
Huawei Technologies Proprietary
4-50
debugging: Debugging information.
level: Level.
severity: Information level, do not output information below this level.
Table 4-10 gives detailed severity information:
Table 4-10 Severity levels defined in the information center
Severity Value Description
emergencies 1 Emergent errors
alerts 2 Errors you must correct immediately
critical 3 Critical errors
errors 4 Errors requiring your attention but not critical
warnings 5 Warning, an error may occur
notifications 6 Information requiring your attention
informational 7 General prompt information
debugging 8 Debugging information
By default, the information level of each channel is as follows:
Table 4-11 Default information level of each channel
channel
Log information
level
Trap information
level
Debugging
information level
Console warning debugging debugging
Terminal warning debugging debugging
Log host informational debugging debugging
Trapbuffer informational warning debugging
Logbuffer warning debugging debugging
SNMPagent debugging warning debugging
Logfile warning debugging debugging
Channel7 debugging debugging debugging
Channel8 debugging debugging debugging
Channel9 debugging debugging debugging
By default, the information switch state of each channel is shown in
Table 4-12:
To Next Page
Loading...
