WebEML User Manual Upgrade MPT-HL to MPT-HL L1 LAG port
1065
9. Download and save the Current Configuration file. See View NE Inventory data
for a detailed procedure to download and save the current configuration file.
10. Create L1 LAG port. See Administer L1/L2 radio and L2 Ethernet LAG ports for
a detailed procedure to create L1 LAG port.
11. Add MPT-HL radio interface to L1 LAG port. See Administer L1/L2 radio and L2
Ethernet LAG ports for a detailed procedure to create L1 LAG port.
When you add the radio port to the L1 LAG port, the message in Figure 779 will
display.
Figure 779 MPT-HL to L1 LAG information message
12. Click on the OK button.
After you click on the OK button, the message in Figure 780 will display.
Figure 780 MPT-HL to L1 LAG warning message
13. Click on the Yes button.
14. Wait for the system to migrate services to the L1 LAG port.
The time required for the system to migrate the MPT-HL radio port to the L1 LAG
port is dependent upon radio port provisioning (synchronization, PPP RF,
number of; port segregations, VLANs, and cross-connections provisioned).
Typical migration duration is two minutes or less. Allow up to five minutes for the
system to migrate all services from the MPT-HL radio port to the L1 LAG port.
When the system has completed migrating to the L1 LAG port you will be
prompted to close the craft terminal.
15. Close the craft terminal.
16. Reopen the craft terminal and log in to the NE.
17. Verify that the radio direction is alarm free.
18. Verify that the radio direction is error free and operating as expected.
Release 7.0.0 3DB 19286 ACAA Issue 01
To Next Page
Loading...