WebEML User Manual Configure EFM OAM
213
28 Configure EFM OAM
28.1 Purpose
This chapter provides procedures to provision Ethernet First Mile Operations,
Administration, and Maintenance.
28.2 Overview
EFM OAM can be enabled on any User Ethernet interface on the Core or EAS cards
or the MSS-1 or MSS-O units.
The interface must be enabled to enable the EFM OAM. If EFM OAM is enabled, the
port cannot be disabled unless the interface is configured as a Ring port.
If the interface belongs to an Ethernet LAG, enabling the EFM OAM is on a per
interface basis.
EFM OAM can be enabled on the User Ethernet interfaces of a Core belonging to a
TMN In-Band networking interface.
EFM OAM must be disabled before performing any of the following:
• provisioning an MPT on the interface
• provisioning PFoE on EASv2, MSS-1 or MSS-O
• configuring the TMN Local User Ethernet interface on User Ethernet Port 4
28.3 Procedures
This section provides the following procedures:
• To enable an OAM link
• To disable an OAM link
To enable an OAM link
1. From the Main Menu Bar, select Configuration >ETH OAM Configuration.
Release 7.0.0 3DB 19286 ACAA Issue 01
To Next Page
Loading...