Nokia 9500 MPR - 43 Provision Cross Connections; Purpose; General

WebEML User Manual Provision cross connections
347
43 Provision cross connections
43.1 Purpose
The procedures in this chapter are used to provision cross connections from the
Cross Connections screen. For AUX cross-connections, see Configure AUX cross
connections (ETSI market only).
43.2 General
Cross connection is only required for TDM traffic. Generic Ethernet traffic is handled
automatically via MAC Address learning in the Ethernet switch. Cross connections
can also be used with point-to-point VLAN Ethernet traffic to direct traffic based on a
VLAN tag rather than MAC address.
The cross connections screen (MSS-4/8) is used to configure switching of packetized
data through the MSS-4/8 Core card. See Figure 191 for an example of the MSS-4/
8 Cross Connections screen.
Release 7.0.0 3DB 19286 ACAA Issue 01