Open and run performance monitoring
980
WebEML User Manual
The 24-h PM data is always stored in the History Data report.
Default and Elaborated PM counters are available. Default counters are collected on
the NE. Elaborated counters are calculated on the PC.
67.3 Procedures
This section provides the following procedures:
• To open the PM tool
• To run PM on an Ethernet port
• To run PM for compression gain statistics
• To run PM on a radio Ethernet port
• To run PM on an L1 radio LAG port
• To run PM on a radio port
• To run Adaptive Modulation PM on a radio port
• To run PM on a PDH port
• To run PM on an SDH port
• To run RSL History PM
• To create a TCA threshold
• To modify a TCA threshold
• To delete a TCA Threshold
• To assign TCA Alarm thresholds to Radio Channels/Link
• To view PM data
• To export PM history data
To open the PM tool
1. From the main toolbar, select the PM Tool icon (see Figure 735) or from the
main menu bar, select Diagnosis>Performance Monitoring.
Figure 735 PM Tool icon
The Acknowledgement of Authorization dialog box opens; see Figure 736.
Release 7.0.0 3DB 19286 ACAA Issue 01
To Next Page
Loading...