WebEML User Manual Deprovision equipment ports
459
50 Deprovision equipment ports
50.1 Purpose
This chapter provides procedures to deprovision equipment ports.
50.2 Prerequisites
Cross-connections associated with the equipment port must be disabled prior to
deprovisioning the equipment port.
50.3 Procedures
This section provides the following procedures:
• To deprovision a Core SFP port
• To deprovision a P8ETH or EASv2 card SFP port
• To deprovision an E1/DS1 P32E1DS1 port
• To deprovision a DS3 P2E3DS3 port
• To deprovision an SDH port
To deprovision a Core SFP port
1. Select MSS/Core-Main slot #1/2 in the resource tree area. The selected name
will highlight in blue. This selection also highlights the MSS/Core card in blue on
the graphical representation of the MSS shelf in the resource list area.
2. Click the Settings Tab in the resource detail area. See Figure 276.
Note: All procedures are shown using the MSS-8 screen, however, the operation is similar
for all MSS shelves.
The Core graphics in this chapter show the Core-E card. The procedure is similar for a
CorEvo card.
Release 7.0.0 3DB 19286 ACAA Issue 01
To Next Page
Loading...