Nokia 9500 MPR - Figure 266 Resource List Area: P2 E3 DS3 Selected

WebEML User Manual Provision equipment port
447
Figure 266 Resource list area: P2E3DS3 selected
The PDH Main View displays. See Figure 267.
2. Provision DS3 port using the following procedure:
See Figure 267 for the following steps:
a. Select Settings tab.
The Settings tab displays.
b. Select DS3 port#n to provision: 01 to 02.
c. Configure a user label if needed.
d. From the Signal Mode drop-down menu, select signal mode type:
Unframed or Framed.
e. From the Service Profile drop-down menu, select service profile type,
TDM2TDM or TDM2Eth.
f. Enter the Line Length (distance to cross-connect): 0 to 450.
g. From the AIS Signal Type drop-down menu, select AIS signal type: AllOnes
or BlueSignal.
h. Enter the unique Flow ID number.
i. DS3 port service profile TDM2ETH?
a. If yes, go to step j
b. If no, go to step m
Release 7.0.0 3DB 19286 ACAA Issue 01