WebEML User Manual Provision cross connections in a mixed fiber/
microwave Ring
667
Figure 481 Node A to Node C: PDH-Ring cross-connection on Node C
a. Choose the flow IDs to cross-connect from the Available VLANs list
b. Choose the Service profile: TDM2TDM or TDM2ETH
c. Choose the Clock Source, if the Service profile is TDM2ETH
d. Enter the Ring Destination MAC address: Node A Unicast MAC address
4. Configure a pass-through cross-connection on Node D, see Figure 482.
Release 7.0.0 3DB 19286 ACAA Issue 01